Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Baumatic CAN52.4ME
Summary of Contents for Baumatic CAN52.4ME
- Page 1 CAN52.4ME CAN75.3SS Canopy hood...
- Page 2 User Manual for your Baumatic CAN52.4ME 52 cm CAN75.3SS 75 cm Canopy Hood NOTE : This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference;...
-
Page 3: Table Of Contents
5 – 7 Specifications of your cooker hood 8 – 10 CAN52.4ME CAN75.3SS 9 - 10 Using your Baumatic cooker hood 10 - 11 Before first use To use your cooker hood 10 - 11 Cleaning your Baumatic cooker hood 11 –... -
Page 4: Environmental Note
Cut the cable off directly behind the appliance to prevent misuse. This should be undertaken by a competent person. o The packaging materials that Baumatic uses are environmentally friendly and can be recycled. o Please discard all packaging material with due regard for the environment. -
Page 5: Important Safety Information
IMPORTANT SAFETY INFORMATION Your safety is of the utmost importance to Baumatic. Please make sure that you read this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Customer Care Department. - Page 6 o The edges of the cooker hood are sharp – be mindful of this as you handle your appliance, especially during installation and cleaning. DO NOT CLEAN IN BEHIND THE GREASE FILTERS! o If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then its flue must be of the sealed or balanced flue type.
- Page 7 o Remember that when in extraction mode, your cooker hood is removing air from your room. Ensure that proper ventilation measures are being observed. o Note that it removes odours from your room, not steam. o Warning - Always ensure that the cooker hood been disconnected...
-
Page 8: Specifications Of Your Cooker Hood
Specifications of your cooker hood CAN52.4ME Product dimensions Height: 162 mm Width: 520 mm Depth: 296 mm Your canopy hood is fitted with: o Slider control operation o Integrated axial motor o 3 speeds o 1 washable aluminium grease filter... -
Page 9: Can75.3Ss
1 pair S1 Carbon filters for air recirculation mode DK5 1 metre length ducting kit 125 mm Ø DK10 3 metre length ducting kit 125 mm Ø with flat channelling included. All of the optional extras are available from the Baumatic Spares Department. -
Page 10: Using Your Baumatic Cooker Hood
Using your Baumatic cooker hood Before first use IMPORTANT: THIS PROCESS MUST BE FOLLOWED BEFORE THE COOKER HOOD IS USED FOR THE FIRST TIME. o You should use a good quality stainless steel cleaner on ALL of the stainless steel areas of your cooker hood, before it is used for the first time. -
Page 11: Cleaning Your Baumatic Cooker Hood
IMPORTANT: IDEALLY YOU SHOULD SWITCH ON YOUR HOOD TEN MINUTES BEFORE YOU START TO COOK, OR AT THE VERY LEAST WHEN YOU BEGIN COOKING. YOU SHOULD ALSO RUN YOUR HOOD FOR TEN MINUTES AFTER YOU HAVE FINISHED COOKING. Cleaning your cooker hood IMPORTANT: BEFORE CLEANING, ALWAYS ENSURE THAT YOU HAVE SWITCHED YOUR COOKER HOOD OFF AT THE OMNI-POLAR SWITCH, SET AT THE... -
Page 12: The Grease Filter
The grease filter o Your cooker hood includes a grease filter which helps to absorb grease particles to protect your kitchen and furniture from greasy residues. o The metallic filter may become flammable if it becomes saturated with greasy residue. o To prevent this fire hazard, the filter should be cleaned regularly. -
Page 13: Changing A Light Bulb
o Refit the grease filter once it has dried. o IMPORTANT: Let the grease filter dry thoroughly before refitting it in the cooker hood. Changing a light bulb IMPORTANT: BEFORE ATTEMPTING TO CHANGE A LIGHT BULB, YOU MUST ENSURE THAT YOU HAVE DISCONNECTED THE COOKER HOOD FROM YOUR MAINS SUPPLY. -
Page 14: Fitting The Carbon Filters
o Insert a new identical 40W (max) bulb. o IMPORTAN T: Defective bulbs should be replaced immediately. o If the lights still do no t work, make sure that the bulbs are fitted properly into their housings before you call for technical assistance. -
Page 15: The Grease Filter
2) Hook the carbon filter over the pins that are located at the end of the motor. ) Turn the carbon filter clockwise until you feel it latch nto the motor’s sides. 4) Replace the grease filters. o When replacing the carbon filter, follo w the steps outlined above and turn the carbon filter anti-clockwise to unlatch it from the motor. -
Page 16: Installation
3) Turn the carbon filter anticlockwise, until you feel it click into place. o Repeat this process for the second carbon filter. You need to place a carbon filter at either end of the motor. o Refit the grease filters. o The carbon filters should be replaced every 3 - 6 months or if they show signs of damage. -
Page 17: Electrical Connection
lectrical connection YOUR COOKER HOOD IS INTENDED FOR FITTED AND PERMANENT INSTALLATION. o The cooker hood’s power cable must be fitted upstream from the electrical connection, using an omni-polar switch with a contact distance of at least 3 mm. THE FUSE MUST BE RA TED AT 3 AMPS. -
Page 18: Installing Your Cooker Hood
o Ensure that all electrical connections are carried out by a suitably qualified person. o Before commencing installation of the cooker hood the grease filter should be removed. o Check inside the product and ensure that there is no transit packaging or any other materials, such as packets of screws, guarantees etc. - Page 19 20). 3) Make a hole in the inside of the kitchen unit for the electrical cable to feed through. Remove the 2 screws (4 screws for CAN52.4ME) securing the extract or frame (B) to the hood and unscrew the 2 lights.
-
Page 20: Connecting To External Ducting
The discharge o utlet should have a cross section of at least 150 cm² (please note that the ducting hose is not supplied with the appliance but one can be obtained from the Baumatic Spares Department). o The maximum dis tance between the coupling and your discharge outlet should be 3 metres, with one 90 degree bend. -
Page 21: Completing The Installation
Completing the installation o If you are setting the appliance to recirculation mode, then you should now fit the two carbon filters. See the “Fitting the carbon filters” section on pages 14-16. o The electrical connection must correspond to the electrical requirement noted on the rating plate, which is placed inside the cooker hood. -
Page 22: Troubleshooting
Recirculation: Extraction: Do I need a charcoal filter? All cooker hoods have a grea se filter but if you are using your cooker hood in recirculation mode, then ch arcoal filters must be fitted in ddition to the grease filter. Troubleshooting IMPORT ANT: If your cooker hood appe... - Page 23 If the hood is set up for recirculation mode, check that the ca bon filters do not need to be replaced. o If the hood is set up for extraction mode, check that the ducting hose and discharge outlet are not blocked. My cooker hood is noisy and/or vibrating.
- Page 24 Or any installation other than the one specified by Baumatic Ltd. has been completed. lease refer to the conditions of guarantee that appear on the arranty card that you receive with the appliance.
-
Page 25: Baumatic Consumables
BC005 Stainless Steel Cleaner and Protector (250ml) o BC007 E-Cloth – General Purpose Cloth o BC008 Microwave Cover o order a Baumatic consumable product please call 0123 5437 244 nd quote the product code. You can also order online from shop.baumatic.co.uk... -
Page 26: Contact Details
Facebook: Via Galvani N.3 www.facebook.com/baumatic.uk 35011 Campodar sego (PD) epublic of Ireland +3904 9920 22 ww.baumatic.it ervice Telephone -890 812 724 Holland Baumatic Benelux B.V. pares Telephone Dukdalfweg 15d 91 756 771 1332 BH ALMERE Nederland +31(0)36 549 1555 www.baumatic.nl...
Need help?
Do you have a question about the CAN52.4ME and is the answer not in the manual?
Questions and answers