Extension Cords - 230V - Alto Bext-100 Operator's Manual

Pin Earthing Contact
European Plug
Side Earthing Contact
Figure 7
Clavija de contacto de
conexión a tierra
Enchufe europeo
Contacto lateral de
conexión a tierra
Figura 7
Lamelle de mise à la
masse
Prise européenne
Contact latéral de
mise à la masse
Figure 7
Page 20
INSTRUCTIONS FOR CONNECTION TO THE
POWER SUPPLY AND ELECTRICAL GROUND -
230 V
CAUTION: This machine will operate only on
This machine must be connected to an electrically
grounded circuit in order to protect the operator from
electric shock. This machine has an approved power
cord with three conductors as well as a plug with three
terminals. Connect the plug to a three holed receptacle.
For maximum protection against electric shock, use a
circuit that is protected by a ground fault circuit inter-
rupter.
This machine uses a 230 volt AC 50/60 cycle electrical
circuit. Make sure you have the correct frequency and
voltage before connecting the power cord to an outlet. The
machine has a plug as shown in Figure 7. If a receptacle
connected to the electrical ground as shown in Figure 7
is not available, contact an electrical contractor. Do not
use an adapter.
WARNING: To prevent possible electric shock,
WARNING: To prevent possible electric shock,
WARNING: If the cords or plugs are worn or
Extension Cords
Use only an approved extension cord with three conduc-
tors, a plug with three terminals and a three-holed
connector body. This machine has a power cord with a
wire size of 12 AWG. (AWG stands for American Wire
Gauge).
CAUTION:
B
CLARKE TECHNOLOGY EXT
an AC frequency and on the speci-
fied electrical voltage shown on
the nameplate. Make sure you
have the correct frequency and
voltage before connecting the
power cord to an outlet.
protect the machine from rain.
Keep the machine in a dry build-
ing.
always use a 3-wire electrical sys-
tem connected to the electrical
ground. For maximum protection
against electrical shock, use a cir-
cuit that is protected by a ground
fault circuit interrupter. Consult
your electrical contractor.
damaged in any way, have them
replaced by an authorized service
person.
If you use an extension cord, use
one that has a minimum wire size
of 12 AWG. Be sure your extension
cord is no longer than 50 ft. Do not
join two extension cords.
®
-100, 100H, 300HV 230V Operator's Manual