Frigidaire 30" GAS SLIDE-IN RANGE Installation Instructions Manual page 2

30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
NOTE:
1. Do not pinch the power supply cord or the flexible gas conduit between the range and the wall.
2. Do not seal the range to the side cabinets.
3. 24" (61 cm) minimum clearance between
the cooktop and the bottom of the
cabinet when the bottom of wood or
metal cabinet is protected by not less
than ¼" (0.64 cm) flame retardant
millboard covered with not less than
No. 28 MSG sheet metal, 0.015"(0.4
mm) stainless steel, 0.024"(0.6 mm)
aluminum, or 0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance when
the cabinet is unprotected.
4. For cutouts below 22 7/8"(58.1 cm),
appliance will slightly show out of the
cabinet.
5. Allow at least 19 ¼" (48.9 cm) clearance
for door depth when it is open.
*** IMPORTANT:
more than 30 / " (76.4 cm), make sure the appliance is centered in the counter opening
1
16
while pushing into it. Raise leveling legs at maximum position, insert the appliance in
the counter and then level.
not by the cooktop glass itself.
IMPORTANT:
Cabinet and countertop
width should match the cutout width.
E
E
A. HEIGHT B. WIDTH
35 5/8" (90.5 cm) - 30" (76,2 cm)
36 5/8" (93cm)
(Models with Sealed Top Burners)
Door Open
(see note 5)
To avoid cooktop glass breakage for cutout width (E dimension) of
Make sure the unit is supported by the leveling legs
C. COOKTOP D. DEPTH TO
WIDTH FRONT OF RANGE
31½" (80 cm) 28 5/16" (71,9 cm)
21¾"
(55.25 cm)
B
FRONT
OF
CABINET
E. CUTOUT WIDTH ***
(Countertop and Cabinet)
30±1/16" 21 3/4" (55,2 cm) Min.
(76,2±0,15 cm) 22 1/8" (56,2 cm) Max
24" (61 cm) Min. with
2
C
A
D
Side panel
22 7/8" (58.1 cm) min.
23 1/4" (59.05 cm) max.
(see Note 4)
1 1/8"
(2.86 cm)
F
Ref.
F. CUTOUT G. HEIGHT
DEPTH OF COUNTERTOP
36 5/8" (93 cm) Max.
35 5/8" (90.5 cm) Min.
backguard