Class B Devices - Honeywell MS5145 – 00 User Manual

Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.

Class B Devices

The following is applicable when the scanner cable is
less than 3 meters (9.8 feet) in length when fully
extended:
Les instructions ci-dessous s'appliquent aux cables de
scanner ne dépassant pas 3 métres (9.8 pieds) de long
en extension maximale:
Folgendes trifft zu, wenn das Scannerkabel kürzer als 3
Meter ist:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and
receiver
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician
for help
Notice
This Class B digital apparatus complies with Canadian
ICES-003.
Remarque
Cet appareil numérique de classe B est conforme à la
norme canadienne NMB-003.
17