Keyboard Wedge - Honeywell MS5145 – 00 User Manual

Keyboard Wedge

1. Turn off the host system.
2. Plug the male, 10-pin RJ45
end of the PowerLink cable
into the 10-pin socket on the
MS5145.
3. Disconnect the keyboard
from the host/PC.
4. Connect the Y ends of the
PowerLink cable to the key-
board and the host's
keyboard port. If necessary,
use the supplied adapter
cable to make the
connections.
5. Plug the external power
supply into the power jack
on the Power Link cable.
6. Check the AC input require-
ments of the power supply
to make sure the voltage
matches the AC outlet. The
outlet must be located near
the equipment
7. Connect AC power to the transformer.
8. Turn on the host system.
Installation Note
Powering the MS5145-47 directly from the computer
can sometimes cause interference with the operation
of the scanner or the computer. Not all computers supply
the same current through the keyboard port, explaining
why a scanner may work on one computer and not
another. Contact a customer service representative if an
external power supply is required.
See caution on page 5.
Figure 7. Keyboard Wedge
6