Resetting The Custom Defaults: All Application Work Groups; Using The Scanner With Bluetooth Devices; Bluetooth Secure Simple Pairing (Ssp) - Honeywell Xenon 1910 User Manual

To see what the factory default settings are, refer to the table of
uct default settings for each of the commands are indicated by an asterisk (*).
Note: Scanning this bar code also causes both the scanner and the base or Access Point to perform a reset and become
unlinked. The scanner must be placed in the base, or the Access Point linking bar code must be scanned to re-establish
the link. Refer to Scanner
If your scanner is in multiple scanner mode, you will hear up to 30 seconds of beeping while all scanners are relinked to
the base or Access Point and the settings are changed.

Resetting the Custom Defaults: All Application Work Groups

If you want the custom default settings restored to all of the work groups, scan the Custom Product Default Settings bar code
below. (If there are no custom defaults, it will reset the work groups to the factory defaults.) See "Setting Custom Defaults" on
page 1-13 for further information about custom defaults.
Note: Scanning this bar code also causes both the scanner and the base or Access Point to perform a reset and become
unlinked. The scanner must be placed in its base, or the Access Point linking bar code must be scanned to re-establish
the link. Refer to Scanner
If your scanner is in multiple scanner mode, you will hear up to 30 seconds of beeping while all scanners are relinked to
the base or Access Point and the settings are changed.

Using the Scanner with Bluetooth Devices

The scanner can be used either with the charge base, an Access Point, or with other Bluetooth devices. Those devices include
personal computers, laptops, PDAs, and Honeywell mobility systems devices.

Bluetooth Secure Simple Pairing (SSP)

Secure Simple Pairing (SSP) allows you to connect simply and securely to other Bluetooth devices without having to enter
a PIN code (as described in
tooth version 2.1 or higher. When SSP is on, no PIN is required for pairing. Turn SSP off if you are connecting to a Blue-
tooth device that is not using a compatible Bluetooth version. Default = Bluetooth SSP On.
Note: SSP is only available with Granit 1981i scanner.
* Bluetooth SSP On
Modes, page 3-9 for additional information.
Custom Default Settings:
All Work Groups
Modes, page 3-9 for additional information.
Bluetooth HID Keyboard Connect
Menu Commands, beginning on page 12-4. The standard prod-
procedure below). SSP is only available when using Blue-
Bluetooth SSP Off
3 - 21