Manual Mode; To Start; To Shut Down; To Adjust The Heat - Travis Industries AGP PI Installation Instructions Manual

Manual Mode

Manual mode requires the user to turn the heater on and off manually and select the heat output setting.

To Start

Press the START button on the control panel.
The insert will enter the start-up sequence for
approximately 22 minutes.

To Adjust the Heat

Turn the HEAT knob on the
control panel to the left
(lower heat) or right (higher
heat). The HEAT knob
adjusts the rate of pellets
feeding into the insert.
© Travis Industries
Operation

To Shut Down

Press the STOP button on the control panel. The
insert will begin the shut-down process, which
takes approximately 45 minutes.
4141230
27
100-01341