Table of Contents
Advertisement
8. INSTALLATION OF THE PRODUCT
8.1 TEMPLATE
• Tear off the Template page (60p) at the back of this manual and use the Template to drill two
6-32 holes and one ½" hole on the proper location of the wall to mount the Wall Mount bracket
as shown below.
(If the gang box is installed on the wall, skip this step.)
• Using 2 screws, install wall mount to the wall.
Before mounting the FINGER007SRB unit to the Wall Mount bracket, an operational test
※
Caution
of the unit should be completed, because the locking pins will lock the unit to the Wall
:
Mount. Removing the unit from the Wall Mount bracket after it has been snapped in
place may cause damage to the bracket and prevent reattachment.
19
Advertisement
Table of Contents
