Connecting/Using A Decoder [A637Eh Only] - JVC HR-A637E Instructions Manual

4
EN
Connecting/
Using A
Decoder
(A637EH only)
TV Receiver
AV2 IN/DECODER
AV2 SELECT switch AV1 IN/OUT
INSTALLING YOUR NEW RECORDER (cont.)
RF Cable
TV Aerial
(provided)
Cable
Rear View
Decoder
SET TV CHANNEL
3
Set your TV to the video channel (UHF channel 36).
Two white bars appear on screen vertically.
Tune the TV until the bars are as clear as they can be.
Your TV should be set to the channel designated for
use with a video recorder, or to a spare channel if
there is not a specified video channel on your TV.
RESET OUTPUT MODE
4
Return the RF TEST switch to OFF.
NOTES:
If CH36 is occupied by a local station, adjust the RF output
channel adjustment screw to use another channel between
CH32 and CH40 instead.
If some interference noise is continually seen on the screen,
consult your JVC dealer.
The AV2 IN/DECODER connector can be used as an input
terminal for an external decoder (descrambler). Simply connect
a decoder and you can enjoy the variety of programming that is
available through scrambled channels.
SELECT INPUT MODE
1
Set the AV2 SELECT switch to "DECODER".
CONNECT DECODER
2
Connect your recorder's AV2 IN/DECODER connector
to the decoder's Euroconnector using a 21-pin SCART
cable.
SET TUNER
3
Follow the procedure starting on page 7.