Connecting/Using A Satellite Tuner - JVC HR-A637E Instructions Manual

Connecting/
Using A
Satellite Tuner
TV Receiver
AV2 IN (/DECODER)
AV1 IN/OUT
AV2 SELECT switch
Satellite antenna
Satellite tuner
TV Aerial
RF Cable
Cable
(provided)
Rear View
Decoder
The AV2 IN (/DECODER) or AV1 IN/OUT connector can be
used as an input terminal for a satellite tuner. Simply connect a
satellite tuner and you can enjoy the wide variety of satellite
programming.
CONNECT SATELLITE
TUNER
1
Connect an optional 21-pin SCART cable between the
satellite tuner's Euroconnector and your recorder's AV2
IN (/DECODER) connector.
SELECT INPUT MODE
(A637EH only)
2
Set the AV2 SELECT switch to "AV2".
PREPARE TO WATCH A
SATELLITE PROGRAMME
3
Select the appropriate channel on the satellite tuner.
Then set the auxiliary mode by pressing NUMBER key
"0" or TV PROG. on the remote control until "AU2"
appears on the recorder's front display panel.
NOTE:
When connecting a satellite tuner together with a decoder . . .
. . . first connect the decoder to the decoder input of the
satellite tuner, then connect the satellite tuner's output to
the recorder's AV2 IN (/DECODER) connector.
Refer to the instruction book for the satellite tuner and
decoder.
5
EN