Set Stations; Fine-Tuning Channels Already Stored - JVC HR-A637E Instructions Manual

SELECT NEW POSITION
2
Press PUSH JOG% fi to move the station to the new
channel position, then press OK.
Example: If you moved the station in position 3 to
position 7, the stations originally in positions 4–7 each
move up one position.
Repeat steps 1 and 2 as necessary.
RETURN TO NORMAL
DISPLAY
3
Press CH SET.
Perform steps 1 and 2 of "Storing Channels Manually" on
page 24 to access the Confirmation display before continuing.
Set Stations (A)
SELECT ITEM
1
Press PUSH JOG%fi until the item you want is
displayed. Then press OK twice and the station's name
(or "– –") begins blinking.
SELECT NEW STATION
2
Press PUSH JOG %fi until the new station's name you
want to store begins blinking.
Registered station names (
press PUSH JOG % fi.
SWITCH STATIONS
3
Press OK.
Repeat steps 1 through 3 as necessary.
RETURN TO NORMAL
DISPLAY
4
Press CH SET.
Set Stations (B)
NOTE:
First perform step 1 of the above procedure.
SELECT STATION NAME
CHARACTER
2
Press PUSH JOG and the first letter of the station
name (or " – ") begins blinking.
pg. 26) appear as you
ENTER NEW CHARACTER
3
Press PUSH JOG % fi to cycle through the characters
*
(A–Z, 0–9, –, , +, (space)) and stop when the
desired one is indicated, then press PUSH JOG to
enter. Enter the remaining characters the same way
(maximum of 4).
After entering all characters, press OK.
Repeat steps 1 through 3 as necessary.
If you make a mistake, press PUSH JOG
incorrect character begins blinking. Then enter the
correct character by pressing PUSH JOG% fi .
RETURN TO NORMAL
DISPLAY
4
Press CH SET.
Fine-Tuning Channels
Already Stored
SELECT CHANNEL TO
FINE-TUNE
1
Press PUSH JOG% fi until the channel you want to tune
is displayed.
ACCESS MANUAL CH. SET
DISPLAY
2
Press OK three times. The Manual Ch. Set display
appears.
"OFF" (decoder setting) appears only with A637EH.
PERFORM TUNING
3
Press PUSH JOG % fi until the picture is its clearest.
Then press OK.
The Confirmation display appears.
Repeat steps 1 through 3 as necessary.
RETURN TO NORMAL
DISPLAY
4
Press CH SET.
25
EN
until the