List Of Messages - Canon HV20 Instruction Manual

Trouble? ••••
List of Messages
Some error messages will disappear after being displayed for about 4 seconds.
Message
Explanation/Solution
OJ
SET THE TIME ZONE,
You have not set the time zone, date and time. This message
24
DATE AND TIME
appears each time you turn the power on until you set the time
zone, date and time
CHANGE THE BATTERY
Battery pack is exhausted. Replace or charge the battery pack. 18
PACK
THE TAPE IS SET FOR
Cassette is protected. Replace the cassette or change the position
92
ERASURE PREVENTION
of the protect switch.
REMOVE THE CASSETTE Camcorder stopped operating to protect the tape. Remove the
20
cassette and reinsert it.
CHECK THE HDVIDV The DV cable is not correctly connected to the HDVIDV terminal, or
66
INPUT the connected digital device is turned off.
(Appears only if a DV cable
IS
The video input signal is in a different television system (PAL or
-
connected)
SECAM).
CONDENSATION HAS
Condensation has been detected in the camcorder. 94
BEEN DETECTED
CONDENSATION HAS Condensation has been detected in the camcorder. Remove the
94
BEEN DETECTED cassette.
REMOVE THE CASSETTE
TAPE END Tape reached the end. Rewind the tape or replace the cassette.
-
INCORRECT TAPE You attempted to play back a tape recorded in a different television -
SPECIFICATION
system (PAL or SECAM) or in a recording standard not supported
by this camcorder.
INPUT SIGNAL NOT The digital device connected with the DV cable is incompatible with
-
SUPPORTED the camcorder.
PLAYBACK STD LOCKED
Current camcorder settings do not match the HDVlDV standard of 40
INCOMPATIBLE VIDEO the Video input signal. Change the [PLAYBACK STD] setting to
INPUT match the video input signal.
PLAYBACK STD LOCKED Current camcorder settings do not match the HDV/DV standard of 40
PLAYBACK IS the recording you tried to play back. Change the [PLAYBACK STD]
RESTRICTED to match the recording standard of the tape.
HEADS DIRTY, USE
Video heads are dirty. Clean the video heads. 94
CLEANING CASSETTE
NO CARD There is no memory card in the camcorder.
20
NO IMAGES No images are recorded on the memory card.
-
CARD ERROR
A memory card error occurred. The camcorder cannot record or
-
display the image.
The error may be temporary. If the message disappears after 4
seconds and"
OJ"
flashes red, turn the camcorder off, remove the
card and reinsert the card. If"
OJ"
changes to green or yellow, you
can continue recording/playback.
CARD FULL Memory card is full. Erase some images to free some space or 64
replace the memory card.