Section3 Installation; Locating The Scales; Setting Up The Scales; Setting Up The Local Scale - Intelligent QHD Series User's Operation Manual

SECTION 3 INSTALLATION

3.1 LOCATING THE SCALES

3.2 SETTING UP THE SCALES

3.2.1 SETTING UP THE LOCAL SCALE

• The QHD Series comes with a stainless steel platform packed separately.
• Place the platform in the locating holes on the top cover.
• Do not press with excessive force as this could damage the load cell inside.
• Level the scale by adjusting the four feet. The scale should be adjusted such that the
bubble in the spirit level is in the center of the level and the scale is supported by all
four feet.
• The scales should not be placed in a
location that will reduce the accuracy.
• Avoid extremes of temperature. Do not
place in direct sunlight or near air
conditioning vents.
• Avoid unsuitable tables. The table or
floor must be rigid and not vibrate.
• Avoid unstable power sources. Do not
use near large users of electricity such as
welding equipment or large motors.
• Do not place near vibrating machinery.
• Avoid high humidity that might cause
condensation. Avoid direct contact with
water. Do not spray or immerse the
scales in water.
• Avoid air movement such as from fans or
opening doors. Do not place near open
windows or air-conditioning vents.
• Keep the scales clean. Do not stack
material on the scales when they are not in
use.
- 3-