Table of Contents
Advertisement
Overcurrent shut down (during acceleration/deceleration/
Protection/warning function
constant speed), regenerative overvoltage shut off.
electronic thermal overload. stall prevention
Ambient temperature
-10 to +50°C (-10 to +40°C for totally enclosed type)
(with no freezing)
»,
Ambient humidity
90% RH or less (with no dew condensation)
•
fr
Storage temperature
*9
-20 to +65°C
is
Indoors with no corrosive or flammable gases. oil mist or
Atmosphere
dust
Altitude/vibration
Less than 1000m above sea level. 5.9m/S'(O.6G) or less
-51-
1,000
5,000
HP
rating
o to ,
(Note)
*8. The braking torque shows the short time average deceleration torque when the motor without
load is decelerated in the shortest time from 60Hz (changes due to motor's loss), and is not
the continuous regenerative torque. For deceleration from a frequency that exceeds the base
frequency. the average deceleration torque value will decrease.
A brake resister is not built-in and cannot be extemally installed.
1.5K is not available for the single phase input series.
*
9. This is a short time temperature
for
during transportation, etc.
*
10. The low-acoustic noise series use the high carrier frequency sinusoidal PWM control.
*
11. The output current is displayed only while the SET key is being pressed.
*
12. Short Cirunit Ratings
The drive is suitable
for
use on a circuit capable of delivering not move than
*
RMS
symmetrical Amperes.
Hide quick links:
Advertisement
Table of Contents
