Pan/Tilt; One-Shot And Multi-Shot - Imi Tech PEARL IMB-20FT User's Operation Manual

Page 60
5.2.1.

Pan/Tilt

Pan/Tilt is a function used to move a camera up and down or left and right. However, unlike the mechanical Pan
/Tilt which is carried out by physically moving the camera up and down, this function by using a smaller video mode
than the CCD's effective pixels and moving the image up and down. This results in a reduced resolution, which the
user can specify by the Pan/Tilt command. Pan/Tilt range and values depend on the characteristic of each CCD
used in the camera respectively as per the following tables. Note that at Format 7 mode, the pan/tilt value must
be set at non-format 7 mode before operation.
5.3.

One-Shot and Multi-Shot

This camera supports One-Shot and Multi-Shot features. The camera should be in ISO disabled mode before the
execution of these commands. If the camera is in ISO enabled mode, these commands are ignored. One-Shot is
used to grab only one frame. Multi-Shot is used to grab 1~65,535 frames. One-Shot and Multi-Shot can be used
combined with a hardware trigger which grabs either one frame or multi frames according to the respective
command. The command can be executed configuring the following registers.
Caution : One-Shot and Multi-Shots are Not supported in trigger mode
Address
Data
nnnn is the number of output frames which can be any number between 0001h ~ FFFFh.(1~ 65,535)
Priority of the command execution is as follows.
When a command with higher priority is being executed, the command with lower priority will be ignored. This
function is Not supported by the IMx-xxFC series
Physical CCD Pixel
Effective Pixel
Kh
1
Kh = Kh + Kh
1
One-Shot
F0F0061CH
80000000h
Continuous > One-shot > Multi-shot.
Kv
1
Kh
2
of
CCD
Kv
2
Kv = Kv + Kv
2 1 2
Multi-Shot
Address
Data
P i o n e e r i n D i g i t a l V i s i o n T e c h n o l o g y
PEARL SERIES Operation Manual
F0F0061CH
4000nnnh