Table of Contents
Advertisement
3/ ASSEMBLY
COMPUTER INSTALLATION
STEP 13:
Prepare Computer for installation. See Picture #1. Remove 4 bolts and extend 3 wires from the back of the
computer. Do not install batteries in holder at this time. Note square ridge that will match up with metal
computer bracket on handlebars.
Connect the three wires from the handle bars to the three wires on the computer. These wires should snap
together easily. Do not force. Two wires are the same and it won't matter which is going to which wire. The 3rd
wire is different and can only connect to each other. (See Figure #4)
Carefully tuck the extra wire into the hole in the back of the computer and/or into the plastic cover to allow the
computer to be placed on the metal bracket. If the wires are too long, the extension wires can be disconnected to
shorten the length. This will not effect the function. (See Figure #4) highlight section.
4
3
5
6
Use 4 computer bolts to secure computer to brackets. tighten firmly but Do not over tighten.
Install 2 AA Batteries (included in Computer box) into the computer and replace cover.
- 10-
Advertisement
Table of Contents
