Table of Contents
Advertisement
3/ ASSEMBLY
STEP 9:
Remove elastic cord from around the tension adjuster knob and then cut the cord to remove from the cover.
Slide the cover down to the bottom of the center upright tube and fit the tabs into the holds in the lower plastic
housing to fit snuggly in place as shown. Apply only gentle pressure to fit the tabs and the cover in place.
Slide the rubber circle down the center upright tube and push into place as shown.
15
FIXING THE HANDLE BARS
1
STEP 10:
a.
The Center Upright Tube has a plastic cover at the top. On the left side, you will notice a wire.
(See Figure #1 above.). Make sure to place this over the back of the plastic lower cover so that when you
place the handle bars on the bolts, the wire is behind the handle bars.
b.
Place handle bars on top of cover and align holes in bracket with the bolts protruding from the plastic
section. While placing the handle bars on the bolts, hold the wire (as mentioned above) to the back to avoid
being caught under the handle bars. (See Figure #2 above.)
c.
Install 4 Nuts onto bolts and secure with T-Wrench (include in tools). Tighten firmly.
16
17
2
18
3
- 8 -
19
4
Advertisement
Table of Contents
