JVC dla-x3 User Manual page 40

Adjustments and settings in the menu (continued)
Anamorphic
A
B
Off
Screen Adjust
Black Level
[3-1] Lens Control
Focus
Zoom
Shift
Lens Cover
Auto
Open
Image pattern
On
Off
Lock
On
Off
[3-2] Pixel Adjust
The video images are projected after being enlarged in the vertical direction of the panel
resolution. This setting is used when one uses the anamorphic lens to enlarge them in the
horizontal direction.
(*) Anamorphic mode cannot be set when there is a 3D signal input.
If a 3D signal is fed in when Anamorphic mode is set to A or B, Anamorphic mode is
automatically turned Off.
Settings: A, B, Off
Video with an aspect ratio of 2.35:1 is enlarged in the vertical direction of the panel
resolution and then projected.
Video with an aspect ratio of 16:9 are displayed by reducing them in the horizontal
direction, without changing their size in the vertical direction.
Used when watching video images other than those with a 2.35:1 aspect ratio while using
an anamorphic lens. 2.35:1 video images are projected without any changes. (Black
bands appear on all sides)
It corrects the white balance fault according to the reflective properties of the projection
screen. Please adjust to your preference.
Sets the black level when used indoors.
Settings: 0 to 10
It controls each motorized functions of the lens during the projector-installation.
This function is used to adjust the focus.
This function is used to adjust the zoom.
This function is used to adjust the shift.
This function is used to set if the lens cover should be linked with a power supply for
opening/closing, or if it should be left open.
Settings: Auto, Open
This opens/closes the lens cover when it is linked to on/off of a power supply.
Regardless if the power supply is on on/off, the lens cover is always open.
It is possible to adjust the projection screen during adjustment of the focus zoom shift.
Settings: On, Off
During the adjustment, the image pattern is displayed.
The image pattern is displayed in conjunction with the above setting items.
The external input signal is displayed without displaying the image pattern.
This sets the lens control to on/off.
Settings: On, Off
It is not possible to adjust the above setting items. If the remote control button "LENS"
button is pressed, a warning message is issued.
This functions as lens control function.
This fine tunes each slight color errors in the horizontal/vertical directions of the video
images in units of 1 pixel.
(*) It is impossible to match all image pixels on the screen. Due to the equipment, there
will always be some gaps.
(*) In case the image is reversed, or upside-down, the horizontal and vertical directions
are reversed.
(*) Please perform adjustments on a clear still picture.
(*) For fine tuning, the effects of adjustments may be difficult to understand for some
video images.
ENGLISH
[Off]
[0]
[Auto]
[On]
[Off]
53