JVC dla-x3 User Manual page 39

3
Adjustments and settings in the menu (continued)
3D Format
Auto
Frame Packing
Side by Side
Top & Bottom
2D
[2-2] COMP. X7 X9
Color Space
Y Pb/Cb Pr/Cr
RGB
[2-3] PC
Auto Alignment
Tracking
Phase
Picture Position
Horizontal
Vertical
[3] Installation
Lens Control
Pixel Adjust
Installation Style
Front
Ceiling Mount (F)
Rear
Ceiling Mount (R)
Keystone
Horizontal
Vertical
52
Operation
Sets the format of the 3D input signal.
(*) It is recommended to read "On 3D" (reference page: 53) before watching 3D video
images.
Settings: Auto, Frame Packing, Side by Side, Top & Bottom, 2D
Is set automatically.
Select this if the 3D input signal is the frame pack method.
Select this if the 3D input signal is the side by side method.
Select this if the 3D input signal is the top and down method.
Projected as a 2D signal.
(*) It can be set when the COMP. terminal is selected.
It configures the input signal method of the component input terminal.
Settings: Y Pb/Cb Pr/Cr, RGB
It is set for the component video image input signal.
It is set for the RGB video image input signal.
(*) Setting can be done when selecting a PC terminal.
The picture position of Tracking and Phase are automatically adjusted.
Adjusts the size and display of the horizontal direction and display area of the video
images.
(Depending on the signal, there is normally no need to be adjusted.)
Adjusts the flickering and blur of the video images.
(Depending on the signal, there is normally no need to adjustment.)
Adjust the display of the picture position.
Adjusts the horiz. of the video image.
Adjusts the vertical position of the image.
To Sub-menu "[3-1] Lens Control"
To submenu "[3-2] Pixel Adjust"
Matching the state of the projector's projection, one can switch horizontal and vertical flip
/ forward switch.
Settings: Front, Ceiling Mount (Front), Rear, Ceiling Mount (RE)
Front upright projection mode.
Ceiling/front projection mode.
Rear upright projection mode.
Ceiling/ rear projection mode.
In regards to the projection plane, any occurring keystone distortion is adjusted in case
the installation location is inclined.
(*) There may be instances, when the video image - after having corrected keystone
distortion - will not match the screen. The position with a shift correction of 0% position is
an exception.
(*) When there is a 3D input signal, adjustment is not possible.
Adjusts the horizontal keystone.
Settings: -40 to 40
Adjusts the vertical keystone.
Settings: -30 to 30
[Auto]
[Y Pb/Cb Pr/Cr]
[Front]
[0]
[0]