Kodak ESP 5250 Start Here Manual page 14

Safety nformation
• Read and follow these instructions before using KODAK Products.
• Always follow basic safety procedures.
• Follow all warnings and instructions marked on the equipment.
WARNING STATEME TS
• Do not expose this product to liquid, moisture, or extreme temperatures.
KODAK AC Adapters are intended for indoor use only. The use of controls,
adjustments, or procedures other than those specified herein may result in
exposure to shock and/or electrical or mechanical hazards.
• Keep ink cartridges out of reach of children. Ink may be harmful if swallowed.
• Do not place your AII-in-One Printer on an unstable cart, stand, bracket, or
table. Injury to persons and damage to the equipment may occur.
• The use of an accessory attachment that is not recommended by Kodak, such as
an AC adapter, may cause fire, electric shock, or injury.
• Pushing objects through the equipment openings can result in an electric shock
or risk of fi reo
CAUTIONARY STATEMENTS
• Adjust only those controls covered in the operating instructions.
• Do not disassemble this product; there are no user-serviceable parts inside.
Refer servicing to qualified service personnel.
• The AC adapter power supply is equipped with 3-wire grounding type plugs. If
you cannot insert the plug into the power outlet, contact an electrician to check
or replace the power outlet.
• Do not plug the AC adapter into a household extension cord.
• If the power cord or plug is frayed or damaged, the equipment gets wet, or the
equipment does not operate normally when the operating instructions are
followed, unplug your All-in-One Printer from the power outlet and contact
Kodak qualified service personnel for further instructions.
• For added protection from damage during a lightning storm, or any time when
your AII-in-One Printer and its associated AC adapter will be left unused for
long periods of time, unplug the AC adapter from the power outlet and any
attached fax line from the printer.
• To prevent your AII-in-One Printer from overheating, do not place it near a heat
register, or install it in a cabinet without proper ventilation.
• Do not use your All-in-One Printer near water or spill liquid on it.
• Unplug the equipment from the wall outlet before cleaning.
• Dropping your AII-in-One Printer may damage the housing and result in
extensive damage that will require repair by a qualified technician to restore
normal operation.
• Excessive dust levels may damage internal parts.
For more information, go to vww.koda .com/go/MSDS
14 www.kodak.com/go/aio5upport