Loading And Unloading A Video Cassette - JVC TV 13142 User Manual

LOADING AND UNLOADING A VIDEO CASSETTE

Use only video cassette tapes marked
LOADING
Push the center of the tape until it is automatically retracted into the TV/VCR.
AUTOMATIC POWER ON AND PLAY
When loading a cassette tape without the erase prevention tab intact, the TV/VCR will turn on automatically
and playback will start immediately.
Insert the cassette with its labeled side facing you.
An inverted video cassette cannot be inserted.
UNLOADING
1
To unload a video cassette, press the STOP/
EJECT button on the TV/VCR twice. The first
press will stop the tape in any mode. The second
press will eject the tape.
STOP/EJECT
AUTOMATIC EJECT
If the TV/VCR automatically rewinds the tape to the
beginning (AUTO REWIND FEATURE), the tape will
be ejected automatically. (See NOTE on page 38.)
TO PREVENT ACCIDENTAL ERASURE
After recording, break off the erase prevention tab if
you do not wish to record over the tape.
Erase prevention tab
TAPE SPEED AND MAXIMUM RECORDING TIME
TAPE SPEED
SP (Standard Play)
EP (Extended Play)
32
and
Screwdriver
T-160 T-120
2-2/3 hours 2 hours
8 hours 6 hours
.
Pull the cassette out.
2
•
NOTE: Always eject the tape when not in use.
•
The cassette tape can be ejected even if the
POWER is "OFF".
TO RECORD AGAIN
Cover the hole with vinyl tape.
Be careful the tape does not extend past the edges of
the video cassette housing.
Adhesive tape
VIDEO CASETTE TAPE
T-90
1-1/2 hours
4-1/2 hours
T-60 T-30
1 hour 30 minutes
3 hours 1-1/2 hours