Loading And Unloading A Video Cassette - JVC TV-13140 User Manual

LOADING AND UNLOADING A VIDEO CASSETTE PLAYBACK
Use only video cassette tapes marked _ and S_.
LOADING
Push the center of the tape until it is automatically retractsd into the TVNCR.
AUTOMA'RC POWER ON AND PLAY
When loading a cassette tape without the erase prevention tab intact, the TV/VCR will turn on automatically
and p_aybackwill start immediately.
Insert the cassette with its labeled side facing you.
An inverted video cassette cannot be inserted.
UNLOADING
_1 o unload a video cassette, press the STOP/ mr..iD!
EJECT button on the TVNCR twice. The first
press will stopthe tape in any mode. "me second
press wiJI eject the tape.
S_Op/EJECt"
AUTOMATIC EJECT
If the TVNCR automatically rewinds thetape to the
beginning (AUTO REWIND FEATURE), the tape will
be ejected automatically. (See NOTE on page 34.)
TO PREVENT ACCIDENTAL ERASURE
rafter recording, break off the erase prevention tab if
you do not wish to record over the tape.
Pull the cassette out.
NOTE: • Always eject the tape when not in use.
• The cassette tape can be ejected even if the
POWER is "OFF".
TO RECORD AGAIN
Cover tbe hole with vinyl tape.
Be careful the tape does not extend past the edges of
the video cassette housing.
TAPE SPEED AND MAXIMUM RECORDING TIME
_r VIDEO CASE3"FE TAPE
%160 T-120 T-90 T-60 T-30
SP (Standard Play) 2-2/3 hours 2 hours 1-1/2 hours 1 hour 30 minutes
LEP (Extended Play) 8 hours 6 hours 4-1/2 hours 3 houm 1-1/2 hours
28
To play a prerecordedtape.
TO START PLAYBACK
Totorn ontheTVNCR, pressthe POWERbutton,
Load a prerecorded tape. (When loading a cassette tape without the erase prevention tat
playback will start automaticaity.)
Press the PLAY buifon th beg_ playt_d_
=I_ "wiUabpear _ _,_eso'cert.
TO STOP PLAYBACK
press the STOP button once. The ta
remain fully loaded and ready to play.
%
NOTE: This TV/VCR selects the tape speed SP or EP automatically.
29