JVC XM-448BK Instructions Manual page 26

OR
SET
ENTER
OR
OR
24
3 Select a track number to be erased, then press SET.
Select a track number by turning the jog dial on the main unit or by pressing < / 4 or
¢ / > on the remote control unit.
Then press SET on the main unit or on the remote control unit.
• You can also use the numeric keys on the cover panel of the remote control unit to
select a track number, then press SET. To select a track, see "Selecting a track with
the numeric keys" on page 9.
If you selected a wrong track number, press 7 STOP/CANCEL on the main unit or
•
CANCEL on the remote control unit and select the correct track number.
• If the display shows "TRACK PROTECTED", the selected track has been protected
against accidental erasure by another component. You cannot edit such a protected
track. To cancel the editing, press EDIT on the main unit or on the remote control
unit.
4 Press ENTER on the main unit or on the remote control
unit.
The change made above is entered temporarily in memory. The display shows
"EDITING" and the TOC indicator lights up.
5 Press 0 on the main unit or on the cover panel the remote
control unit to eject the MD.
The data in memory is written in the MD before it is ejected.
The display shows "UTOCwriting" during MD writing operation.
• Be careful not to apply impact to the MD recorder during writing temporarily stored
data into the MD. Otherwise the recording may not be able to play later.
• The data in memory is written in the MD also when the power is turned off while
"EDITING" is being displayed.
To cancel editing:
Press EDIT repeatedly on the main unit or the remote control unit before pressing ENTER
in step 4.
Caution
• Once erased, the track can never be restored. An MD
containing recording that you do not want to erase should
be protected by sliding the protect tab (see page 14).
Blinks Blinks
Example) When track No. 2 is to be erased
Blinks
Example) When SET is pressed
Decrements by 1
Blinks
1 2 3 4 5
6
Blinks
1 2 3 4 5
6
1 2 3 4 5