Table of Contents
Advertisement
Connection to CD player or CD changer
32
Without connecting the receiver (or amplifier) equipped with the TEXT COMPU LINK
remote control system, this connection enables you to record the track title information of
the CD Text onto an MD in its original form, when recording from the CD player.
To use this control system, connect the units as follows:
1. If the CD player (or CD changer) and this unit have
already been plugged into the AC outlets, disconnect
their AC power cords.
2. Connect the CD player (or CD changer) and this unit as
described below using the COMPU LINK-3 (SYNCHRO)
and TEXT COMPU LINK jacks.
1
COMPU LINK-3 (SYNCHRO) jacks: Use the supplied Compu Link cable (with
the monaural mini-plugs: black).
CD player
2
TEXT COMPU LINK jacks: Use the supplied Text Compu Link cable (with the
stereo mini-plugs: green.
CD player
IMPORTANT: Without setting the
MASTER/SLAVE selector correctly, the
TEXT COMPU LINK remote control
system does not work.
3. Connect the CD player and this unit using the audio pin
cord (and a digital cable if any) (see page 6).
4. Connect the AC power cord of the CD player to the AC
outlets.
5. Finally connect the AC power cord of this unit.
Set the MASTER/SLAVE
selector on the rear panel
to "1 (MASTER UNIT)."
COMPU LINK- 3
(SYNCHRO)
TEXT COMPU LINK
1 (MASTER UNIT)
2 (SLAVE UNIT)
Advertisement
Table of Contents
