Fire Door Glass; Door Adjustment - Valor The Arden Operating & Installation Manual

OPERATING INSTRUCTIONS

FIRE DOOR GLASS

In the event of the door glass being broken it can
easily be replaced:
•The door should be lifted off the hinges so that
the above operations can be carried out on a
workbench or similar level surface. This should be
done when the appliance is cold (fig.8)
Fig 8 removal of stove door
•Unscrew the two nuts, on the inside of the door
securing the retaining clips.
•Carefully remove any pieces of broken glass, and
sealing gasket wearing suitable gloves.
REFIT NEW GASKET
•The fitting of new gasket is shown below (fig.9a)
Fig. 9a fitting new door gasket
14
•Re-seat the new glass, ensuring the sealing gasket
is flat and in contact with the glass.
Fig 9b fitting new glass
•Replace the two retaining clips and nuts. Do not
over-tighten the nuts as damage may occur to the
glass (fig.9c)
Fig. 9c tightening nuts
ADJUSTING THE DOOR HINGES
Once the appliance has been under fire for a period
of time the fire door may appear to have moved out
of alignment with relation to the door aperture or
catch. This is quite normal and due to the settling of
the casing.
The fire door can be re-aligned by the user as
follows:
•When the appliance is cold, open the fire door so
that it is at right angles to the front of the fire.
•Lift the fire door up off its hinges (fig.8).
The Arden Multifuel Stove