Table of Contents
Advertisement
Chapter 2
Installing your SMART Audio
system
Installing speaker wires and Cat 5e cables
Run the speaker wires to the speakers and run the Cat 5e cable between the control unit and
room module before you begin installation. If you want to place the wires and cables out of
sight, run the cables in the walls and ceiling.
WARNING
•
Check your local building codes to determine whether you require plenum-rated
speaker wires and speakers to reduce the risk of fire.
•
Take appropriate safety precautions when working at ceiling height, and use a sturdy
ladder to reduce the risk of personal injury.
To install speaker wires
1. Remove the ceiling tile at the location of each of the four ceiling speakers.
OR
Cut a wiring hole in the wall where you will mount each of the four wall speakers.
2. Remove the ceiling tile at the location of the room module.
3. Run the speaker wires from the speaker locations in the ceiling or wall to the location for
the room module.
IMPORTANT
For each speaker wire, identify the positive and negative strands and mark each end
accordingly.
5
|
1012080 Rev A1
Advertisement
Table of Contents
