Table of Contents
Advertisement
CH AP TE R 2
Installing your SMART Audio system
Attaching cables to the control unit
For more information, see the SMART Audio system cabling diagram on page 4.
Control unit connectors
USB B receptacle
Auxiliary inputs
To connect cables to the control unit
1. Connect the Cat 5e cable from the room module to the room module connector on the
control unit.
2. Connect the control unit to a power outlet with the included power cable.
3. Connect the included USB cable from the control unit to your computer.
4. If you have a SMART Board interactive whiteboard system, connect the RCA cable (with
two connectors on each end) from your projector to the Aux In 1 connectors.
NOTE
The Aux In 1 input is a mono input, not a stereo input.
5. If you have a secondary audio device like a CD player, connect the RCA cable from the
device to the Aux In 2 connectors.
6. Connect a recording feed or an assistive listening device to the Line out / ALS out
connector.
7. Attach the cable cover to the mounting plate.
IMPORTANT
If you connect cables that run from outside of the wall,
snap and remove the break-away plate at the bottom of
the cable cover so you can connect the cables to the
control unit.
14
|
1012080 Rev A1
A ux In
Out
Line out / ALS out
Power input receptacle
19 V DC
To R M
RESE T
Room module connector
Advertisement
Table of Contents
