Connecting Audio/Video Components; Analog Connections - JVC RX-DP9VBK Instructions Manual

Enhance your audio system
You can use this receiver as the pre-amplifier (control amplifier)
when you connect power amplifiers to the PREOUT jacks on the
rear panel, using cables with RCA pin plugs (not supplied).
• Connect the white plug to the audio left jack, and the red plug to
the audio right jack.
Left front speaker
Power amplifier
RIGHT
FRONT
SUB
WOOFER
SURR
SURR
BACK
Power amplifier
Left / right
Surround speakers
9
Right front speaker
Center speaker
Power amplifier
LEFT
CENTER
R L
PREOUT

Connecting Audio/Video Components

You can connect the following audio/video components to this
receiver. Refer also to the manuals supplied with your components.
Audio Components
• Turntable
*
• CD player
• Cassette deck
*
or MD recorder
*
• CD recorder
* You can connect these components using the methods described in
"Analog connections" (below) and in "Digital connections" (see
page 14).

Analog Connections

Audio component connections
Use the cables with RCA pin plugs (not supplied).
• Connect the white plug to the audio left jack, and the red plug to
the audio right jack.
CAUTION:
If you connect a sound-enhancing device such as a graphic equalizer
between the source components and this receiver, the sound output
through this receiver may be distorted.
Turntable
If a ground cable is
provided for your
turntable, connect
the cable to the
screw marked (H)
on the rear panel.
To audio output
Turntable
Note:
The above connection is for a turntable with an MM (moving-magnet)
type cartridge.
Any turntables incorporating a small-output cartridge such as an MC
(moving-coil) type must be connected to this receiver through a
commercial head amplifier or step-up transformer. Direct connection
may result in insufficient volume.
Video Components
*
• DVD player
*
• TV
• DBS tuner *
• VCRs
• Video camera
AUDIO
RIGHT LEFT
PHONO
CD
OUT
(REC)
TAPE
MD
IN
(PLAY)
OUT
(REC)
CDR
IN
(PLAY)
FRONT
SUB
WOOFER CENTER
SURR
(REAR)
R L
DVD