Making Sounds Natural; Changing The Display Brightness; Changing The Source Name - JVC RX-DP9VBK Instructions Manual

Making Sounds Natural

JVC's CC (Compensative Compression) Converter eliminates jitter
and ripples, achieving a drastic reduction in digital distortion by
processing the digital music data in 24 bit–quantization and by
expanding the sampling frequency to 176.4 kHz (for fs 44.1 kHz
signals)/192 kHz (for fs 48 kHz signals).
By using the CC Converter, you can obtain a natural sound field
from any source.
Press CC CONVERTER so that the CC
CONVERTER lamp lights up.
• Each time you press the button, CC Converter turns on and off (the
lamp goes off) alternately.
CC CONVERTER
On the unit
Note:
You cannot use this function while Line Direct or THX Surround is in
use. If you turn on Line Direct or THX Surround while this function is
in use, this function will be canceled.

Changing the Display Brightness

You can dim the display.
Press DIMMER.
• Each time you press the button, the brightness level of the display
changes as follows:
D I M M E R
On the unit
Dimmer
Canceled
(Normal display)
Note:
Even though the dimmer is in use, the display brightens for a while
when you operate the receiver (except when changing the source).
CC CONVERTER
On the remote control
DIMMER
On the remote control
Much dimmer

Changing the Source Name

When you have connected an MD recorder to the TAPE/MD jacks
or the DBS tuner to the TV SOUND/DBS jacks on the rear panel,
change the source name which will be shown on the display when
you select the MD recorder or DBS tuner as the source.
On the unit ONLY:
When changing the source name from "TAPE" to
"MD":
1. Press TAPE/MD.
2. Press and hold TAPE/MD until
"ASSGN. MD" appears on the display.
ANALOG
L R
SUBWFR
When changing the source name from "TV " to
"DBS":
1. Press TV/DBS.
2. Press and hold TV/DBS until "ASSGN.
DBS" appears on the display.
ANALOG
L R
SUBWFR
To change the source name to "TAPE" or "TV," repeat the same
procedure above — press and hold TAPE/MD to select "TAPE," or
press and hold TV/DBS to select "TV" in step 2.
Note:
Without changing the source name, you can still use the connected
components. However, there may be some inconvenience.
– "TAPE" or "TV" will appear on the display when you select the MD
recorder or DBS tuner.
– You cannot use the digital input (see page 20) for the MD recorder.
– You cannot use the COMPU LINK remote control system (see page
47) to operate the MD recorder.
TAPE/MD
SPEAKERS 1
VOLUME
dB
TV/DBS
SPEAKERS 1
VOLUME
dB
22