Connecting The Speakers - JVC RX-DP9VBK Instructions Manual

AM Antenna Connections
1 2
ANTENNA
AM
EXT
AM
LOOP
Turn the loop until you
have the best reception.
FM 75
COAXIAL
AM Loop Antenna
Outdoor single vinyl-covered wire (not supplied)
Notes:
• If the AM loop antenna wire is covered with vinyl,
remove the vinyl by twisting it as shown in the diagram.
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord. This
could cause poor reception.
• If reception is poor, connect an outdoor single vinyl-covered wire to
the AM EXT terminal. (Keep the AM loop antenna connected.)
7
3
Snap the tabs on the loop into
the slots of the base to
assemble the AM loop.

Connecting the Speakers

You can connect the following speakers:
• Two pairs of front speakers to produce normal stereo sound.
• One pair of surround speakers to enjoy the surround effect.
• One center speaker to produce more effective surround effect (to
emphasize human voices).
• One powered subwoofer to enhance the bass.
IMPORTANT:
After connecting the speakers listed above, set the speaker
setting information properly:
• To obtain the best possible Surround and DSP effect in the
main room, see "Basic Settings" on pages 26 to 33.
For each speaker (except for a subwoofer), connect the (+) and (–)
terminals on the rear panel to the (+) and (–) terminals marked on
the speakers. For connecting a subwoofer, see page 8.
CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals.
Speaker layout
Left front speaker(s)
Center speaker
Left surround
speaker
Surround back speakers
Note:
* When connecting the surround back speakers, you have to prepare
another amplifier, see also page 8.
Subwoofer
Right front speaker(s)
Right surround
speaker
*