Table of Contents
Advertisement
Working Instruction Repair Instruction Mechanical/3/000 21-1/FEA 209 544/123, Mechanical
Using a nylon pointer, verify the black retaining bar on the
LCD to board ZIF connector is rotated up as shown.
The LCD's flex connection is completely seated in the
ZIF connector when the two tabs on the flex are against
the ZIF connector.
Using style 2A tweezers, insert the LCD flex film into its
corresponding ZIF connector on the circuit board.
Using a nylon pointer, rotate the black retaining bar on the
ZIF connector down over the LCD flex as shown.
Starting at section 4.1.3, perform the remainder of the
reassembly procedure.
: Preliminary
26(65)
State
Rev 4
© Sony Ericsson Mobile Communications AB
Advertisement
Table of Contents
