JVC RX-8000VBK Instructions Manual page 52

To change the transmittable signals for
operating a CATV converter
1. Set the remote control mode to "CATV/DBS."
2. Press and hold CATV/DBS POWER.
3. Press TV/DBS.
4. Enter manufacturer's code (two digits) using
buttons 1–9, and 0.
See the list below to find the code.
Examples: For an RCA product, press 1, 9.
For a SONY product, press 2, 0.
5. Release CATV/DBS POWER.
After setting the remote control mode selector to "CATV/DBS,"
you can perform the following operations on the CATV
convertor :
CATV/DBS POWER
Turns on and off the CATV converter.
CHANNEL +/–
Changes the channels.
1 – 10, 0, 100+ (+10) Selects the channels.
The 100+ (+10) button will function as
the ENTER button if your equipment
requires pressing ENTER after
selecting a channel number.
Notes:
• Refer to the manual supplied with your CATV converter.
• You cannot set the remote control mode selector both for the
CATV converter and the DBS tuner at the same time.
6. Try to operate your CATV converter by pressing
CATV/DBS POWER.
When your CATV converter turns on or off, you have entered
the correct code.
If there are more than one code listed for your brand of
CATV converter , try each one until the correct one is entered.
Manufacturer
GI JERROLD
HAMLIN/REGAL
PIONEER
RCA
SCIENTIFIC ATLANTA
SONY
ZENITH
Manufacturers' codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
50
Codes
01, 02, 03, 04, 05,
06, 07, 08
15, 16, 17, 18
13, 14
19
09, 10
20
11, 12
To change the transmittable signals for
operating a DBS tuner
1. Set the remote control mode to "CATV/DBS."
2. Press and hold CATV/DBS POWER.
3. Press TV/DBS.
4. Enter manufacturer's code (two digits) using
buttons 1–9, and 0.
See the list below to find the code.
Examples: For a JVC product, press 2, 1.
For an RCA, press 2, 9.
5. Release CATV/DBS POWER.
After setting the remote control mode selector to "CATV/DBS,"
you can perform the following operations on the DBS tuner:
CATV/DBS POWER Turns on and off the DBS tuner.
CHANNEL +/–
Changes the channels.
1 – 10, 0, 100+ (+10)
Selects the channels.
The 100+ (+10) button will function as
the ENTER button if your equipment
requires pressing ENTER after
selecting a channel number.
Notes:
• Refer to the manual supplied with your DBS tuner.
• You cannot set the remote control mode selector both for the
CATV converter and the DBS tuner at the same time.
6. Try to operate your DBS tuner by pressing
CATV/DBS POWER.
When your DBS tuner turns on or off, you have entered the
correct code.
Manufacturer
JVC
ECHOSTAR
GI
HITACHI
HTS
HUGHES
NETWORK SYSTEMS
PANASONIC
PRIME STAR
RCA
SONY
TOSHIBA
Manufacturers' codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
Codes
21
22
23
24
25
26
27
28
29, 30
31
32