Making A Snapshot - Cisco TelePresence Codec C90 Administrator's Manual

Cisco TelePresence System Codec C90 and Profile 65" Dual using C90
Contents Introduction

Making a snapshot

When administering the video system from a remote location,
you can use the web interface snapshot feature to check the
view of the main video input source.
This feature is disabled by default. The feature can be enabled
only when you have direct access to the codec, i.e. from the
on screen menu or by using the command line interface via
the codec serial data port.
Using the on screen menu
From the Advanced configuration menu, navigate to
AllowWebSnapshots and select On to enable the snapshot
feature.
Using the command line interface
Enter the following command to enable the snapshot feature:
xConfiguration Video AllowWebSnapshots <Off/On>.
D14635.0 6 Profile C90 and Codec C90 Administrator Guide TC4.2, July 2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
Web interface Web interface Advanced settings
Video >
Make a snapshot
Press Get snapshot. The
snapshot will be displayed on
the web interface.
Diagnostics
System Information
Logs
XML Files
Snapshot
Password protection
17
Administrator guide
Appendices Contact us
www.cisco.com