Epson AcuLaser M2000D Service Manual page 77

EPSON AcuLaser M2000D/M2000DN/M2010D/M2010DN
PROCEDURE
1. Find the part/unit you want to remove in the table.
2. Check the alphabetic character "Guide" in the Guide column for the target
part/ unit.
Example: When you want to remove the Separation Roller, its "Guide" is
"C".
1.3.4 Group 4
CONTENT
Parts/Units to be Disassembled
Paper Feed Roller (Paper Cassette)
Paper Sensor
Separation Roller (Paper Cassette)
DISASSEMBLY AND ASSEMBLY
Table 1-7.
Guide
A
B
C
3. Go to main pages, find the columns that has the "Guide" character on the
upper left corner, and perform the procedure described in the columns in
numerical sequence.
Example: To disassemble the Separation Roller, find columns with "C"
on their upper left corner, and follow the procedures in the
columns in numerical order.
EPSON AcuLaser M2000D/M2000DN/M2010D/M2010DN
A1 B1
C1
EPSON AcuLaser M2000D/M2000DN/M2010D/M2010DN
B3
Paper Cassette
Bottom
1. Remove the Paper Cassette.
DISASSEMBLY AND ASSEMBLY
1. Put the printer upside down.
2. Pull the Feed Shaft out in the direction of the arrow.
3. Disengage the two hooks and remove the holder.
4. Remove the actuator from the holder.
5. Disengage the hook and remove the Paper Sensor.
6. Disconnect the connector from the Paper Sensor.
DISASSEMBLY AND ASSEMBLY
Preliminary Check
A2 B2
Paper Cassette Paper Feed Roller (Paper Cassette)
Paper Feed Roller
Paper Sensor
C2
Front Face
Paper Feed Roller
Feed Shaft
Hooks
Connector
Bottom Plate
Shape of the Shaft
Actuator
1. Push the lever and remove the Paper Feed Roller.
Match the Feed Shaft end with the oval hole on the Paper Feed Roller.
Paper Sensor
Holder
Feed Shaft
Main Unit Disassembly/Reassembly
1. Secure the Bottom Plate by pressing it down.
Main Unit Disassembly/Reassembly
Revision B
Revision A
Feed Shaft
Revision A
Lever
Separation Roller (Paper Cassette)
Feed Shaft
Separation Roller
Oval shape
32
Confidential
33
Confidential
68
Confidential