Sym GTS 250 Service Manual page 115

To this chapter contents
9. Final Driving Mechanism
Install assembly directs puller bearing puller.
Special Service Tools:
Assembly directs puller SYM-2341110
Use screw driver hold bearing puller lower part,
and turn the bearing puller upper part to install the
drive shaft bearing.
Assembly directs puller
Gear box cover side
Remove drive shaft bearing and counter shaft
bearing from gear box cover using following tools.
Special tool:
Inner bearing puller SYM-6204020 or
SYM-6204021
Inner bearing puller
Remove oil seal, and then remove final shaft
bearing from gear box cover using following tools.
Special tool:
Inner bearing puller SYM-6204022
Inner bearing puller
Install a new drive shaft bearing and counter shaft
bearing into gear box cover.
9-6