Connecting Speakers - JVC HX-Z30 Instructions Manual

AM antenna
1
2 3
ANTENNA
AM
AM EXT
LOOP
FM 75
COAXIAL
5
AM loop antenna
(supplied)
1
If the cords are covered with insulation,
remove a short section of insulation at the
end of each cord by twisting and pulling it
off.
2
Press and hold the clamp of the AM LOOP
terminals on the rear of the unit.
3
Insert the AM loop antenna to the AM LOOP
terminals as illustrated.
4
Release your finger from the clamp.
5
Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
loop antenna must remain connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other terminals
and connecting cords.
• Keep the antennas away from metallic parts of the unit, connecting
cords, and the AC power cord.
7

Connecting Speakers

4
Vinyl-covered wire
(not supplied)
1
2
3
1
2
Speaker cords
(black/blue)
Speaker cords
(black/red)
From right
subwoofer
terminal
From right main
speaker terminal
If the cords are covered with insulation,
remove a short section of insulation at the
end of each cord by twisting and pulling it
off.
Insert the end of the speaker cord into the
terminal as illustrated.
Match the same polarity: (+) to (+) and (–) to (–).
Close the speaker terminals.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
• DO NOT connect more than one speaker to
each speaker terminal.
• DO NOT push or pull the speakers as this will
damage the foot spacers at the bottom of the
speakers.
3
Speaker cords
(black/blue)
From left
subwoofer
terminal
From left main
speaker terminal