Marantz NR1604 Owner's Manual page 28

Measurement (2nd – 6th)
• In this step, you will perform measurements at multiple positions
(one to five additional positions) other than the main listening
position.
• Just one listening position can be measured if you so choose, but
measuring multiple positions increases the accuracy of the correction
of acoustic distortion within the listening area.
10
Move the Setup and
measurement microphone to
position 2, select "Continue",
ENTER
and then press .
The measurement of the second
position starts. Measurements can be
made in up to six positions.
Audyssey Setup
Place the microphone at ear level at the 2nd listening position,
then select "Continue"...
Continue
Calculation
Back
Audyssey Setup
Measuring the LEFT FRONT SPEAKER...
Cancel
• To skip measuring the second and subsequent listening position,
i ENTER
use to select "Calculation" and press
13.
• To measure the second position again, use
ENTER
Last Test" and press .
DVD
11
Repeat step 10, measuring positions 3 to 6.
When measurement
"Measurements finished." message is displayed.
Measurements finished.
Repeat Last Test
to proceed to step
i
to select "Repeat
of position 6 is completed,
Audyssey Setup
Calculation
25
Set up speakers (Audyssey® Setup)
Calculation
12
Select "Calculation" and then press
a
Measuring results are analyzed, and the frequency response of
each speaker in the listening room is determined.
Audyssey Setup
Calibration completed! Now calculating...Please wait.
50%
• Analysis takes several minutes to complete. The more speakers
and measurement positions that there are, the more time it takes
to perform the analysis.
ENTER
.
v See overleaf