Marantz NR1604 Owner's Manual page 27

Preparation (Continued)
5
Select "Start" and then press
ENTER
.
Audyssey Setup
Connect the calibration microphone to the SETUP MIC input
on the front the AV receiver.
Back
6
ENTER
Select "Next" and then press
The subwoofer volume setting screen is displayed.
Audyssey Setup
Make sure your subwoofer is plugged in and turned on. If your
subwoofer has a volume control on it, please set it at 50%...
POWER VOLUME
ON
OFF MIN MAX
Back
DVD
Detection & Measurement (Main)
This step automatically checks the speaker configuration and speaker
size, and calculates the channel level, distance, and crossover
frequency.
It also corrects distortion in the listening area.
7
Select "Begin Test" and then press
When measuring begins, a test tone is output from each
speaker.
• Measurement requires several minutes.
8
The detected speakers are displayed.
• The illustration below shows an example of when the front
speakers, center speaker, subwoofer, surround and surround back
speakers have been detected.
Next
Speaker Detection
.
Front
Center
Subwoofer
Surround
Surr. Back
NOTE
If a connected speaker is not displayed, the speaker may not be
connected correctly. Check the speaker connection.
Next
9
Select "Next" and then press
ENTER
.
Audyssey Setup
:Yes
:Yes
:Yes
:Yes
:2spkrs
Repeat Last Test Next
ENTER
.
24
Set up speakers (Audyssey® Setup)
NOTE
If "Caution!" is displayed on TV screen:
Go to "Error messages" (vpage 27). Check any related items,
and perform the necessary procedures.
If the problem is resolved, return and restart "Audyssey ® Setup".
Going back to the previous screen
Select "Back" and then press ENTER .
When measuring has stopped
BACK
q Press to display the popup screen.
w Press o to select "Yes", and then press ENTER
Setting up the speakers again
Repeat the operation from step 4.
.
v See overleaf