Installation; Connection To The Mains; Fitting The Lamp - Robe Color Wash 700E AT User Manual

Fixtures must be installed by a Qualified electrician in accordance with all
national and local electrical and construction codes and regulation.

4.1 Connection to the mains

For protection from electric shock,the fixture must be earthed!
The ColorWash 700E AT is equipped with auto-switching power supply that automatically adjusts to any 50/60Hz
AC power source from 100-240 Volts.
For use with 100-130 V supplies,the both main 6.3 A fuses has to be exchanged for 10 A fuses which
are enclosed in the packing.
To install the 10 A fuses:
1. Disconect the fixture from AC power.
2. Unscrew the "live" fuseholder on the rear panel of the base with a flat-tip screwdriver from the housing
(anticlockwise).
3. Remove the 6.3 A fuse from the fuseholder.
4. Put the 10 A fuse in the fuseholder.
5. Replace the fuseholder in the housing and screw it fully clockwise.
6.Repeat steps -5 for "neutral" fuseholder
If you need to fit the power cable with a power plug that is suitable for your local AC power outlets,
installl a 3-prong grounding-type plug on the power cable.The earth has to be connected!
If you have any doubts about proper installation, consult a qualified electrician.
The occupation of the connection cables is as follows:
Cable (EU)
Brown
Light blue
Yellow/Green

4.2 Fitting the lamp

DANGER ! Install the lamps with the device switched off only.
To insert the lamp (MSR GOLD 700 FastFit):
1. Disconnect the fixture from power and allow it to cool
at least 5 minutes.
2. Make sure that fixture´s head is in the position as
shown on the picture.Loosen the two quarter-turn
fasteners (1) marked "X,Y" on the lamp cover (2) to
turn the cover down.
3. Holding the lamp by its ceramic base (3), carefully
turn the lamp to the left as shown on the picture in
order to loosen the lamp from the lamp holder (4).
Gently pull the lamp out of the lamp holder
4. Holding the new lamp by its ceramics base, gently
insert the lamp to the lamp socket and turn the base
to the right. Make sure that the lamp is installed tightly
into the lamp socket.
Do not install a lamp with a higher wattage! A lamp like
this generates temperatures the device is not designed
for. Damages caused by non-observance are not sub-
ject to warranty. Please follow the lamp manufacturer's

4. Installation

Cable (US) Pin
Black Live
White Neutral
Green Earth
Unplug from mains before !
6
International
L
N