Changing The Front Lens; Installing Top Hats - Robe Color Wash 700E AT User Manual

4.5 Changing the front lens

The ColorWash 700E AT is supplied with the front Fresnel lens installed as standard.
If you wish to install a front wide-angle lens (optional),follow the instructions:
Switch the device off before changing the lens.Be careful.Front lens is heavy!
Changing the front Fresnel lens:
1.Remove the front lens using a flathead screwdriver to unlock the four quarter-turn screws.
.Unscrew the safety cabel from the lens
3.Screw up the safety cable to the wide-angle lens.
4.Place this lens and fix it by locking the four quarter-turn screws.
Quarter-turn screws
Quarter-turn
screws

4.6 Installing top hats

The ColorWash 700E AT can be fitted with various types of the top hats-see chapter "Technical specifications".If
you wish to install a top hat (optional),follow the instructions:
Installing the top hat on the front lens-holder of the fixture:
.Loosen 4 lens holder quarter-turn screws and hook both securing springs to the plastic projections in the front
lens-holder.Tighten the 4 lens holder quarter-turn screws again.
.Put desired top hat onto a front lens-holder and fasten it by two fastening screws.
3.Snap both springs to the slots in the top hat.
Fastening screw
Securing spring
Switch the device off before installing the top hat!
Bolt
Safety
cable
Top hat
Fastening screw
Plastic projection
Lens-holder
8
Nut
Slot
Securing spring