Monogram ZIBI240 Owner's Manual page 10

Ice scoop
The bar refrigerator with icemaker includes
an ice scoop in the ice storage bin. To
maximize ice bin capacity, store the ice
scoop as shown. Do NOT wash the ice scoop
in the dishwasher. For cleaning, handwash
in mild soapy water or use the baking soda
solution noted in Cleaning the inside section.
The bottom full extension drawer holds
Loading
five bottles and is loaded with necks facing
tips and
the rear. Tall bottles should not be loaded
suggestions
on the bottom drawer because they may
prevent the door from closing.
• Do not block the thermistor, located on
To remove:
Removing
full extension
1. Pull the full extension drawer out to the
drawer
2. Push the tab on right drawer guide down
To replace:
1. Push the drawer slide arm back into the
2. Pull the small slide sub-assembly
3. Insert the sides of the drawer back into
4. Push until the tabs lock into place.
Interior fan
The interior fan is located in the rear wall
of the bar refrigerator with icemaker and
is designed to run continuously to help
maintain the proper cooling temperature.
10
the right hand side, just above the top
shelf of the bar refrigerator with icemaker.
Blocking the thermistor could impair the
air circulation and temperature control.
STOP position.
while pulling the tab on left guide up, and
pull the drawer out.
unit.
completely forward.
the guides.
Controls and Features
Bar Refrigerator with Icemaker
Bottom drawer arrangement
Appearance may vary
Sub-assembly
To replace, push drawer slide
arm back into unit
NOTE: Make sure the tabs on the full
extension drawer guides are fully engaged
before loading any bottles. Pull the drawers
out all the way to the STOP position and
push back in several times to make sure
locking tabs are properly engaged.
In most instances, the interior fan will run
when the door is open. However, it will not
operate when the door is opened during a
defrost cycle.
Tab (push tab down on right
drawer guide, pull tab up on
left drawer guide)
Sub-assembly
Pull small slide sub-assembly
completely forward