Table of Contents
Advertisement
Figure N4: 234254 CFS Fill-In Cushions
D. Helm "Buddy" Seat
Standard on the 214 Candia FS, I/O model only, is a
double wide helm seat. It is referred to as the "Buddy"
seat because a second person may sit next to the driver.
The seat can be swiveled towards the stern 90
making the cockpit cozier and much easier to interact
with your guests. See Figure N5.
Swivel
Release
Lever
Figure N5: 214 CFS I/O "Buddy" Seat Seat
The "Buddy" seat is also adjustable forward or back.
To adjust, locate the left locking lever under the front of
seat. Push the lever to the left and slide the seat for-
ward or aft to the desired position. The seat will adjust
approximately six (6) inches. See Figure N5.
To swivel the "buddy" seat:
1. Place the tilt wheel in its most upward position by
depressing the release lever (adjusting tab) with your
thumb. Be sure to hold the top of the wheel to assist
in positioning. Release the lever once the steering
wheel is in its most upward position.
Candia FS Owner's Manual
03/00
2. Locate the left locking lever under the front of seat.
Push the lever to the left and slide the seat forward.
When attempting to swivel, ensure the "buddy"
seat clears the coaming pad otherwise, dam-
age to the coaming pad and/or "buddy" seat
will occur.
3. Locate the right most lever under the front of the
seat (swivel release) and push it to the left.
4. Swivel the seat inboard (the only direction possible).
The seat will rotate approximately 90
To return to forward driving position:
1. Rotate the buddy seat outboard (the only direction
possible) until the swivel seat mechanism locks into
place.
2. Position the seat according to the needs of the
O
thus
driver by locating the left locking lever under the
front of seat. Push the lever to the left and slide the
seat forward or aft to the desired position.
3. Tilt the steering wheel to the desired position using
the tilt lever knob on the steering column.
E. Bucket Seats
The bucket seat or captain's chair is adjustable. To ad-
just, lift up on the metal release handle under the middle
of the seat. Slide the seat forward or aft to the desired
position. The seat will adjust approximately six (6) inches.
See Figure N6.
Adjustment
Pull release handle up to
Release Lever
move forward and back.
Friction Adjustment Knob
Figure N6: Bucket Seat Slider Base (Front View)
The driver's side and the port side (if applicable) can
swivel and face the stern of the boat. When pulling a
water skier, this permits the spotter to be in the proper
position to observe.
NOTICE
o
.
Pull lever up to
release pin from
pedestal to swivel
bucket seat.
Section N
Page 2
Advertisement
Table of Contents
