Step2: Programming Trunking Frequencies - Uniden UBC3300XLT Owner's Manual

For Type 1 System, you must enter the block and fleet
numbers. Please refer to "Programming a Fleet Map" on page
67 for instructions.
STEP 1 is complete.
No. LCD display
1 Type 2 800
2 Type 1
3 Type 2 900
4 Type 2 UHF
5 Type 2 VHF
6 EDCS WIDE
7 EDCS NARROW
8 EDCS SCT.
9 LT
STEP 2:
Programming Trunking Frequencies
After you finish selecting the bank and trunk type you want to
track, store the frequencies in the channels for your selected
bank in your scanner. Remember that you can only store one
trunking system in each bank.
Important: If you are programming an EDACS or LTR
trunked system, you must enter the frequencies
in a specific order. Check the frequency guide
included with the scanner for the frequencies in
your area. For additional frequencies, check the
web sites listed on page 11.
1. Press MENU/BACK.
2. Select 2:SCAN OPTION /
2:TRUNK by rotating the VFO and
pressing E.
3. Select the bank number by rotating the
VFO and pressing E.
4. Select 2:TRUNK CHANNEL and enter the channel
number by rotating the VFO and pressing E.
5. Select 1:FREQUENCY and enter a frequency for the
trunked system using the keypad and pressing E.
6. Enter the alpha tag and press E. (See page 49).
7 You can also change the step size in this menu.(See page
92)
Note: • To clear a mistake while entering the frequency,
press
cleared.
Icon TrunkingType
M Motorola Type 2 800 MHz
M Motorola Type 1
M Motorola Type 2 900 MHz
M Motorola Type 2 UHF
M Motorola Type 2 VHF
E EDACS Wideband 9600 baud
E EDACS Narrowband 4800 baud
E EDACS SCAT
L LTR
(decimal key) twice, and the display is
.
Special requirements
a. Must program a fleet map.
b. Must program base, spacing,
frequency and offset channel.
c. Must program frequencies
in exact order and location.
46
CH/
FRQ
HOLD/
RSM
MAN
SCAN AIR/STEP SEARCH
MENU/BACK TRUNK
L/O
REVERSE SELECT
.
E