Uniden UBC3300XLT Owner's Manual page 25

2:TRUNK CHANNEL
1:FREQUENCY
To use Trunk Tracking, you need to
program a frequency for at least one
channel. Also you can enter an alpha
tag for each channel in this Menu.
2:STEPS
You can assign a variety of step sizes
to the channel.
3:TALK GROUP
You can program IDs into the Scan List
memory either during Trunk Scan or Search
without going into the Menu. However, you
can also use the Menu to program IDs.
This is particularly helpful when you are not
near the trunked system you wish to later
monitor. You can set it up and have it ready
to go at some later time. After you have
selected the Scan List location (1-10), you
can then do the following:
1. Program ID number
2. Set an alpha tag
3. Assign a Beep Alert to the ID. Whenever
that ID is active, you will hear three beeps
at the start of the transmission.
4:DELAY
You can set a delay for a trunk system on a
bank by bank basis. The delay time is 2
seconds, and this setting can not be changed.
5:ID LIST TAG
Assign an alphanumeric tag to any or all of
the 10 Scan Lists for the system. During ID
Scan Mode, you will see the ID List Tag (on
the bottom text line) along with any alpha tag
you may have set for an ID. In Search mode,
you will see any Bank Tag you have set.
6:L/O ID REVIEW
Use this Menu item to review the IDs that you
have locked out during Search and Scan.
Rotate the VFO up or down to view the IDs
that have been locked out. To leave the
lockout IDs unchanged, press MENU/BACK
to back out of the Menu. To unlock an ID,
press the L/O key. To unlock all the IDs that
have been locked out, press and hold the L/O
key for about 2 seconds.
21