Disassembly Procedure - Mitsubishi Electric PUHZ-RP35VHA Service Manual

13

DISASSEMBLY PROCEDURE

PUHZ-RP35VHA PUHZ-RP50VHA
OPERATING PROCEDURE
1. Removing the top panel, service panel, front panel and
back panel
(1) Remove the top panel fixing screws (4
right and two from the eft side, and detach the top panel.
(2) Remove 1 service panel fixing screw (4
the service panel by pulling it downward. (See photo 2.)
(3) Remove the front panel fixing screws (4
front, 2 from the right and 2 from the left side, and detach
the front panel.
(4) Remove the back panel fixing screws (4
right and 3 from the rear side, and detach the back panel.
2. Removing the fan motor
(1) Remove the top panel. (See photo 1.)
(2) Remove the front panel. (See photo 1.)
(3) Remove 1 nut (M6, left-screw) and detach the propeller.
(4) Disconnect the connector CNF1 on the controller circuit
board in the electrical parts box.
(5) Loosen the clamp for the lead wire in the motor support.
(6) Remove 4 fan motor fixing screws (4
fan motor. (See photo 3.)
Photo 1
10), one from the
10) and detach
10), 5 from the
Grille
10), 4 from the
Photo 2
Photo 3
18) and detach the
Nut
Photo 4
Fan
motor
(MF1)
101
PHOTOS
Top panel
Front panel
Electrical parts box
Propeller
Fan motor fixing screws
Fan motor fixing screws
Top panel
fixing screws
Back panel
Service panel
for charge
plug
Service panel
Service panel
fixing screw
Pull down
4 hooks
Clamp
Motor support