KitchenAid KESS300B Reference Manual page 30

Accessing Components Under
The following major components are serviced by raising the
cooktop:
- Surface Burner Assemblies
- Ignitors
- Ceran Element Assemblies
END CAP
SCREW
(On Slide-In Models Only)
Refer to Figure 7 for the following steps.
1. Unplug the power cord plug from the AC receptacle, and if necessary,
move the range out from the wall.
2. Open the oven door, and remove the three screws from under the
control panel, and the two from the end caps, then close the oven
door.
3. Set the control panel on the maintop, and remove the four chassis
screws (two on each side) that are under the control panel, then
position the control panel back in its normal location.
4. Lift the front of the maintop and prop it up so you can easily access
the components underneath. Be careful not to stress any of the
wiring when you lift the top.
The Cooktop
- 26 -
RANGE TOP
SCREWS (4)
END CAP SCREW
(On Slide-In Models Only)
CONTROL PANEL
ELECTRONICS BOARD
CONTROL PANEL
SCREWS (3)
FIGURE 7
Accessing Components Under The Cooktop