Baumatic BHC607 Instruction Manual page 23

o Carefully turn the hob back over and then gently lower it into the
aperture hole that you have cut out.
o There are holes on the base or the sides of the hob that you can
fix the four brackets to. There are three holes in each one of the
brackets.
o IMPORTANT: You must observe
the
shown in the drawing opposite.
o IMPORTANT:
holes around the outside of the hob.
YOU MUST ensure that these holes are
not blocked by the work top, when you
put the hob into position (see drawing
opposite).
o Carefully turn the hob upside down and
place it on a cushioned mat.
o IMPORTANT: Do not use a silicon sealant
to seal the appliance against the aperture.
This will make it difficult to remove the hob
from the aperture in future, particularly if it
needs to be serviced.
ventilation requirements
There are ventilation
23