Table of Contents
Advertisement
OPTIMOD-PC
• Stereo
• Mono from the left-channel input
• Mono from the right-channel input
• Mono from the sum of the left and right channel inputs
Choose the functionality you want from the S
on the I/O mixers below the corresponding faders). The default is S
4. Adjust the Processor mixer analog input fader.
[Skip to step 6 on page 2-31 if you will not be using OPTIMOD-PC's analog in-
puts.]
This step adjusts the drive to OPTIMOD-PC's audio processing so that it operates
in its preferred range.
A) Open the ROCK-MEDIUM factory processing preset.
a) On the Orban Control application, choose F
The Open Preset dialog box appears.
b) Click R
OCK
The R
until you explicitly close it by clicking D
B) Calibrate using tone—feed a test tone at your reference level to OPTIMOD-PC.
[Skip this step if you are using program material to calibrate OPTIMOD-
PC to your standard studio level. Skip to step (C) on page 2-30]
•
If you are not using a studio level controller, feed a tone through your
console or mixer at the level at which you normally peak program material
(typically 0 VU if your console uses VU meters).
•
If you are using a studio level controller that performs an AGC function,
such as another OPTIMOD-PC, the Orban 8200ST OPTIMOD-Studio, or the
Orban 464A Co-Operator, adjust it for normal operation.
-M
in the preset list.
EDIUM
preset becomes active. The dialog box remains open
-M
OCK
EDIUM
drop-down list (found
/M
TEREO
ONO
/O
P
.
ILE
PEN
RESET
.
ONE
INSTALLATION
.
TEREO
2-29
Advertisement
Table of Contents
