Orban OPTIMOD-PC 1100 Operating Manual page 6

This equipment generates, uses, and can radiate radio-frequency energy. If it is not
installed and used as directed by this manual, it may cause interference to radio
communication. This equipment complies with the limits for a Class A computing
device, as specified by FCC Rules, Part 15, subject J, which are designed to pro-
vide reasonable protection against such interference when this type of equipment
is operated in a commercial environment. Operation of this equipment in a residen-
tial area is likely to cause interference. If it does, the user will be required to elimi-
nate the interference at the user's expense.
This digital apparatus does not exceed the Class A limits for radio noise emissions
from digital apparatus set out in the radio Interference Regulations of the Canadian
Department of Communications. (Le present appareil numerique n'emet pas de
bruits radioelectriques depassant les limites applicables aux appareils numeriques
(de las class A) prescrites dans le Reglement sur le brouillage radioelectrique
edicte par le ministere des Communications du Canada.)
Perform the installation under static control conditions. Simply walking across a rug
can generate a static charge of 20,000 volts. This is the spark or shock you may
have felt when touching a doorknob or some other conductive item. A much
smaller static discharge is likely to destroy one or more of the CMOS semiconduc-
tors employed in OPTIMOD-FM. Static damage will not be covered under warranty.
There are many common sources of static. Most involve some type of friction be-
tween two dissimilar materials. Some examples are combing your hair, sliding
across a seat cover or rolling a cart across the floor. Since the threshold of human
perception for a static discharge is 3000 V, you may not notice damaging dis-
charges.
Basic damage prevention consists of minimizing static generation, discharging any
accumulated static charge on your body or workstation, and preventing that dis-
charge from being sent to or through an electronic component. You should use a
static grounding strap (grounded through a protective resistor) and a static-safe
workbench with a conductive surface. This will prevent any buildup of damaging
static.
Orban is a registered trademark.
All trademarks are property of their respective companies.
This manual is part number 96112.200.01. Published March 2006.
© Copyright Orban
Phone: +1 510 351-3500; Fax: +1 510 351-0500; E-Mail: custserv@orban.com; Site: www.orban.com
WARNING
WARNING
CAUTION
1525 Alvarado Street, San Leandro, CA 94577 USA
P/N: 96112.200.01