Automatic Mode Operation - Panasonic CS-E9CKP Service Manual

Panasonic ilmalämpöpumput korjaa ja huoltaa pääkaupunkiseudulla: Jäähdytinpalvelu RefGroup Oy
2. Manual horizontal airflow direction can be set using remote controller; the angles of the vane are as stated below and the
positions of the vane are as Figure 2 above.
Pattern
Airflow Direction
Patterns at Remote
Controller
Vane Angle (°)
8.1.8.

Automatic Mode Operation

This mode can be set using remote controller and the operation is decided by remote controller setting temperature, indoor intake
air temperature and outdoor air temperature.
During operation mode judgment, indoor fan motor (with speed of Lo-) and outdoor fan motor are running for 20 seconds to detect
the indoor intake and outdoor air temperature. The operation mode is decided based on below chart.
Values of T1, T2, and T3 depend on remote controller setting temperature, as shown in below table. After the adjustment of T1,
T2 and T3 values, the operation mode for that particular environment and remote controller setting is judged and performed, based
on the above operation mode chart, every 30 minutes. Heating mode operation will be performed, however, if deice operation is
detected.
Remote Controller Setting Temperature (°C)
There is a temperature shifting on T1, T2, and T3 if the operation mode judged is changed from Cooling/Soft Dry to Heating or vice
verse.
Operation Mode change from
Cooling/Soft Dry → Heating
Heating → Cooling/Soft Dry
Example of operation mode chart adjustment:
From the above table, if remote controller setting temperature = 25,
T1 = 25 + 7 = 32; T2 = 25 + 6 = 31; T3 = 25 - 7 = 18
1 2
90 55
16 ~ 18
19 ~ 22
23 ~ 26
27 ~ 30
www.ilmalämpöpumput.com
3
70
T1 T2
+10 +8
+8 +7
+7 +6
+6 +5
Temperature shifts (°C)
25
CS-E9CKP CU-E9CKP5 / CS-E12CKP CU-E12CKP5
4 5
110 125
T3
-5
-7
-7
-8
-2
+2